How to measure the size of cylinder and bearing hole of hydraulic cutting machine? 1. Measurement of bearing hole of cutting machine cylinder The measurement of the bearing hole can be measured after checking the reference size on the outer diameter micrometer using an inner diameter gauge. At...

How to sovle the problem if the pressure plate of the cutting machine doesn't rise after being pressed down? According to the 20 years experience of Shuoying cutting machine, solving this problem is divided into the following steps to eliminate the fault step by step: 1. Check whether the...

1. First, the user needs to treat the problem of the cutting machine objectively. At this time, you can try to increase the pressure value by a value, which may be able to solve this trouble; 2. Through the above method, the machine still suffers from pressure instability, that is, a part of the...

Maintenance of automatic hydraulic cutting machine The automatic cutting machine is the same as a car. It needs some daily maintenance after using for a period of time. So what is included in the maintenance of the cutting machine? First, replace the hydraulic oil The hydraulic oil replacement...

The reason of insufficient pressure of hydraulic cutting machine Insufficient pressure of the hydraulic cutting machine means that the products that could be cut before can not be cut without changing the material and die (cutting continuously, insufficient pressure). What is the cause of the...